FREQ and TYPE you can define the slope of the crossover frequency and also select a filter type. When the
parameter X-OVER ADJUST MODE is set to “LINK”, any changes to the crossover frequency will also shift the
neighboring frequency ranges.
Muting Input/Output Channels (Mute)
Press the MUTE button to enter the MUTE menu. Here you can mute the inputs and outputs of the DCX2496(LE). On
this page you can mute or activate individual channels by pressing the channel buttons (IN A-B / A-C and OUT 1-6),
or all inputs/outputs by pressing the PARAM and OK or CANCEL buttons. Thus, you can monitor each frequency
band, either individually or together with a neighboring band, to allow perfect editing of the isolated frequency range.
To quit the MUTE menu press MUTE a second time.
Storing Presets
Use the STORE button to save your presets.
Recalling Presets
Press the RECALL button to load presets from the internal memory. Select the preset you wish to recall, then press
ENTER. We included some typical presets that you can use as a basis for your own applications.
Restoring the Factory Presets
If you wish to restore the ULTRADRIVE’s factory presets, press and hold both PAGE buttons on the front panel
switching on the unit. The DCX2496(LE) prompts you to confirm (OK) or CANCEL. Press OK to erase the internal
memory and restore the factory presets.
Specifications
To Next Page
Loading...
