Behringer V-AMP User Manual

9
V-AMP
1.3.2 Connectors on the V-AMP side panel
Fig. 1.2: Connectors on the V-AMP side panel
16
Connect the stereo phone plug of your footswitch FS112V to the FOOTSWITCH jack on the V-AMP.
Now you can select different presets from one bank. If you keep the DOWN button of the footswitch
pressed for more than 2 seconds, the tuner is switched on. Use the same button to switch the tuner off
again.
17
Your V-AMP features both MIDI inputs and outputs. Here, you can connect a MIDI controller such as
our BEHRINGER MIDI FOOT CONTROLLER FCB1010.
18
Connect the enclosed power supply to the POWER SUPPLY connector of your V-AMP.
19
The LINE OUT is on 1/4" TRS connectors and provides the audio signal in stereo, for example, to send
it to a recording machine. Depending on the CABINET selected, this output is frequency-corrected
(Speaker Emulation).
+ The LINE OUT works with both balanced and unbalanced 1/4"-jack cables. Use the left line
output to route the audio signal to a guitar amp with mono inputs, however, in this case the
signal from the multi-effects processor will not be available in stereo.
20
AUX LEVEL controls the volume level of the signal received at the AUX input.
21
The AUX IN (1/4" TRS connector) allows you to feed in additional stereo signals, for example, to play
with a drum computer or some sort of playback.
22
The PHONES jack allows you to monitor the V-AMPs audio signal with a pair of commercially available
headphones.
+ If you do not select a specific loudspeaker type when using the headphones, your V-AMP will
automatically use a cabinet to improve the sound image over the headphones. Please see
table 3.1 for more information about which cabinet is assigned to which amplifier model. You
can disable the cabinet simulation by selecting cabinet -.
23
INPUT is the V-AMPs 1/4" jack input for your guitar. Use a commercial 1/4" mono cable.
1.3.3 Serial number
The serial number is printed on the rear panel of your V-AMP. Please take the time to fill out and return the
warranty card within 14 days after the date of purchase, so as to be entitled to benefit from our extended
warranty. Or use our online registration option available on the Internet at www.behringer.com.
1. INTRODUCTION

Behringer V-AMP Specifications

General

Amp Models	32
Form Factor	Desktop
Type	Guitar Amp Modeler
Effects	15
Inputs	1 x 1/4"
Outputs	1 x 1/4" (headphones)
MIDI	In, Out
Footswitch I/O	1 x 1/4" (footswitch)
Power Supply	9V DC adapter