1 Function and area of use
In this document we show how to set IP address, Subnet Mask and Gateway for
programmable I/O module GN-9372.
2 About this Startup document
This Startup document should not be considered as a complete manual. It is an aid to be able
to Startup a normal application quickly and easily.
This Start Up document should not be considered as a complete manual. It is an aid to be
able to start up a normal application quickly and easily.
Use the following software and drivers in order to obtain a stable application:
In this document we have used following hardware and software
• GN-9372 Programmable I/O
• BootpServerVer1000_Beijer Link to BootP
• Windows 10 64 bit
For further information we refer to
• GN-9372 Manual Link
• Beijer Electronics knowledge database, HelpOnline
This document and other Startup documents can be obtained from our homepage.
Please use the address support.europe@beijerelectronics.com for feedback about our Quick
Start documents.
Copyright © Beijer Electronics, 2023
This documentation (below referred to as ‘the material’) is the property of Beijer Electronics. The holder
or user has a non-exclusive right to use the material.
The holder is not allowed to distribute the material to anyone outside his/her organization except in cases
where the material is part of a system that is supplied by the holder to his/her customer.
The material may only be used with products or software supplied by Beijer Electronics.
Beijer Electronics assumes no responsibility for any defects in the material, or for any consequences that
might arise from the use of the material.
It is the responsibility of the holder to ensure that any systems, for whatever applications, which is based
on or includes the material (whether in its entirety or in parts), meets the expected properties or
functional requirements.
Beijer Electronics has no obligation to supply the holder with updated versions.
To Next Page
Loading...