Beko CNK321EC0A - Installation Guide; Proper Installation Location and Setup

28 / EN
Refrigerator / User manual
3 Installaton
3.1. Right place for installation
Contact the Authorized Service for the
product's installation. To ready the product
for installation, see the information in the
user guide and make sure the electric and
water utilities are as required. If not, call an
electrician and plumber to arrange the utilities
as necessary.
B
WARNING: The manufacturer assumes
no responsblty for any damage caused
by the work carred out by unauthorzed
persons.
B
WARNING: The product’s power cable
must be unplugged durng nstallaton.
Falure to do so may result n death or
serous njures!
A
WARNING: If the door span s too narrow
for the product to pass, remove the door
and turn the product sdeways; f ths
does not work, contact the authorzed
servce.
• Place the product on a flat surface to avod
vbraton.
• Place the product at least 30 cm away from
the heater, stove and smlar sources of heat
and at least 5 cm away from electrc ovens.
• Do not expose the product to drect sunlght
or keep n damp envronments.
• The product requres adequate ar
crculaton to functon effcently.
• If the product wll be placed n an alcove,
remember to leave at least 5 cm dstance
between the product and the celng and
the walls.
• Do not nstall the product n envronments
wth temperatures below -5°C.
3.2. Attaching the plastic wedges
Use the plastc wedges n the provded wth
the product to provde suffcent space for ar
crculaton between the product and the wall.
1. To attach the wedges, remove the screws on
the product and use the screws provded wth
the wedges.
2. Attach 2 plastc wedges on the ventlaton
cover as shown n the fgure.
3.3. Adjusting the stands
If the product s not n balanced poston,
adjust the front adjustable stands by
rotatng rght or left.
3.4. Power connection
A
WARNING: Do not use extenson or
mult sockets n power connecton.
B
WARNING: Damaged power cable must
be replaced by Authorzed Servce.
C
When placng two coolers n adjacent
poston, leave at least 4 cm dstance
between the two unts.
• Our frm wll not assume responsblty
for any damages due to usage wthout
earthng and power connecton n
complance wth natonal regulatons.
• The power cable plug must be easly
accessble after nstallaton.
• Connect the refrgerator to an earthed
socket wth 220-240V/50 Hz voltage. The
plug must comprse a 10-16A fuse.
• Do not use mult-group plug wth or
wthout extenson cable between the
wall socket and the refrgerator.