What to do if my Beko Washer does not drain water?
If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted (clean or flatten the hose), or the pump filter could be clogged (clean the pump filter).
Why does my Beko WTC8835XCST Washer not fill with water?
If your Beko Washer isn't filling with water, it could be due to a few reasons: the tap might be turned off (turn on the taps), the water inlet hose could be bent (flatten the hose), the water inlet filter might be clogged (clean the filter), or the loading door may be open (close the door).
Why is my Beko WTC8835XCST Washer leaking water from the bottom?
If your Beko Washer is leaking water from the bottom, the water drain hose might be clogged or twisted; therefore, you should clean or flatten the hose. Also, the pump filter may be clogged; in this case, clean the pump filter.
How to open the loading door of my Beko WTC8835XCST?
The loading door of your Beko Washer might not open because the door lock is activated due to the water level in the machine (drain the water by running the Pump or Spin programme), the machine is heating up the water or is at the spinning cycle (wait until the programme completes), or the child lock is engaged (wait a couple of minutes for deactivation of the door lock).
Why is my Beko Washer vibrating and making noise?
Your Beko Washer may be vibrating or making noise due to several reasons: it might be standing unbalanced (adjust the feet to level the machine); a hard substance might have entered the pump filter (clean the pump filter); the transportation safety bolts are not removed (remove the transportation safety bolts); the laundry quantity might be too little (add more laundry); the machine might be overloaded (take out some laundry or distribute the load evenly); or the machine might be leaning on a rigid item (ensure it's not leaning on anything).
Why does my Beko WTC8835XCST take longer than expected?
Your Beko Washer might take longer than expected due to several reasons: low water pressure (the machine waits until it takes in enough water), low voltage (washing time is prolonged to avoid poor results), low input water temperature (it takes longer to heat the water), increased number of rinses or rinse water amount (the machine increases the amount of rinse water when good rinsing is needed), or excessive foam due to too much detergent (use the recommended amount of detergent).
Why does my Beko WTC8835XCST Washer immediately discharge the water?
If your Beko Washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
General| Type | Washer Dryer |
|---|---|
| Load Capacity (Washing) | 8 kg |
| Load Capacity (Drying) | 5 kg |
| Energy Efficiency Class | A |
| Spin Speed | 1400 rpm |
| Color | Silver |
| Noise Level Washing | 56 dB |
| Noise Level Spinning | 76 dB |
| Number of Programs | 15 |
| Programs | Cotton, Synthetics, Delicates, Wool, Quick Wash |
To Next Page
