What to do if my Beko WTV6611BC1 does not drain water?
If your Beko Washer doesn't drain water, the water drain hose might be clogged or twisted, so try cleaning or flattening it. Also, the pump filter could be clogged; in that case, clean the pump filter.
Why is my Beko WTV6611BC1 Washer leaking water from the bottom?
If there is water leaking from the bottom of your Beko washing machine, the water drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter might be clogged, so clean the pump filter.
How to open the loading door of my Beko WTV6611BC1 Washer?
If the loading door of your Beko Washer cannot be opened, the door lock may be activated because of the water level in the machine. Drain the water by running the Pump or Spin programme. The machine may be heating up the water or it is at the spinning cycle; wait until the programme completes. If the child lock is engaged, the door lock will be deactivated a couple of minutes after the programme has come to an end, so wait for a couple of minutes for deactivation of the door lock. The loading door may be stuck because of the pressure it is subjected to; grab the handle and push and pull the loading door to release and open it.
Why is foam overflowing from the detergent drawer of my Beko WTV6611BC1?
If foam is overflowing from the detergent drawer of your Beko Washer, it could be due to using too much detergent. Mix 1 tablespoonful of softener and ½ l of water and pour it into the main wash compartment of the detergent drawer. Also, put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and consumption table”. When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of detergent.
Why is my laundry still wet after washing in my Beko Washer?
If laundry remains wet at the end of the programme in your Beko Washer, excessive foam might have occurred, and the automatic foam absorption system might have been activated due to too much detergent usage. Use the recommended amount of detergent.
What to do if my Beko WTV6611BC1 enters standby mode or doesn't take in water?
If your Beko Washer enters standby mode after the programme starts or it does not take in water, the tap may be turned off; turn on the taps. The water inlet hose may be bent; flatten the hose. The water inlet filter may be clogged; clean the filter. The loading door may be open; close the door. The water connection may be wrong or water may be cut off (When the water is cut off, washing or rinsing LEDs flash); check the water connection. If the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation from standby mode.
Why does my Beko WTV6611BC1 not rinse well?
If your Beko Washer does not rinse well, the amount, brand, and storage conditions of the detergent used may be inappropriate; use a detergent appropriate for the washing machine and your laundry. Keep detergents closed in an environment free of humidity, and do not expose them to excessive temperatures. Detergent may be put in the wrong compartment; if detergent is put in the prewash compartment although the prewash cycle is not selected, the machine can take this detergent during the rinsing or softener step. Put the detergent in the correct compartment. The pump filter may be clogged; check the filter. The drain hose may be folded; check the drain hose.
Why did my Beko WTV6611BC1 Washer stop shortly after the program started?
If your Beko Washer machine stopped shortly after the programme started, it might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
Why does my Beko WTV6611BC1 immediately discharge the water it takes in?
If your Beko Washer directly discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why is my Beko Washer vibrating and making noise?
If your Beko Washer vibrates or makes noise, it might be standing unbalanced. Adjust the feet to level the machine. A hard substance might have entered into the pump filter; clean the pump filter. Ensure that the transportation safety bolts are removed. The laundry quantity in the machine might be too little, so add more laundry. The machine might be overloaded with laundry, so take out some of the laundry or distribute the load evenly. Ensure that the machine isn't leaning on anything.
Safety instructions to prevent injuries and material damage from product use.
Guidelines for safe use by children and supervision requirements.
Precautions regarding electrical connections, grounding, and wet hands.
Warning about hot surfaces and keeping children away from the door.
Information on product recycling and disposal according to WEEE Directive.
Details on packaging materials and their disposal.
Instructions on selecting a suitable floor and environment for installation.
Steps to remove packaging reinforcement before installation.
Procedure for removing transportation safety bolts before first use.
Instructions for connecting the water supply hose and checking for leaks.
Guidelines for connecting the drain hose to ensure proper water discharge.
How to level the machine using adjustable feet for stability and reduced vibration.
Instructions for safe electrical connection to a grounded outlet.
Preparation steps and first use recommendations, including drum cleaning.
How to sort laundry by fabric, color, and soiling level.
Steps to prepare laundry items before washing, like checking pockets and fasteners.
Advice on optimizing energy and water usage during washing.
Instructions on how to load laundry into the machine correctly.
Guidance on the maximum load capacity for optimal washing performance.
Detailed instructions on using detergent and softener in the dispenser.
Specific instructions for using liquid detergents with or without a special cup.
How to use gel and tablet detergents, including placement.
Instructions for using starch in the washing machine.
Guidance on using limescale removers.
Recommendations for using bleaching agents safely and effectively.
Table providing guidance on detergent and temperature based on soiling and color.
Explanation of the control panel layout and buttons with symbols.
Steps to prepare the machine before starting a wash cycle.
How to select programmes and tips for efficient washing.
Table detailing programmes, load capacity, duration, water, and energy consumption.
Descriptions of main washing programmes like Cotton, Synthetics, and Wool.
Information on additional programmes like Eco 40-60 and Cottons 60°.
Details on the Xpress programme for quick washing.
Information on the Hemden (Shirts) programme for wrinkle reduction.
Usage of the Donsjas programme for washing down-filled items.
Maintenance programme for cleaning the drum.
Explanation of special programmes like Spin+Drain.
How to adjust spin speed and options like Rinse Hold.
How to set a delayed start for the washing programme.
How to modify a set delayed start time.
Steps to cancel a set delayed start.
How to start the selected washing programme.
How to activate and deactivate the child lock feature.
Alternative methods to deactivate the child lock.
How to monitor the progress of a running programme.
Explanation of the loading door lock mechanism and its function.
How to change settings or pause the machine mid-cycle.
Procedure for adding or removing laundry during a paused programme.
How to cancel a running programme.
Steps to follow when the washing programme has ended.
Explanation of the machine's energy-saving pause mode.
Step-by-step guide for cleaning the detergent dispenser.
Instructions for cleaning the drum and door seal.
How to clean the exterior of the machine and its control panel.
Procedure for cleaning the water inlet filters.
Steps to drain water and clean the pump filter.
Solutions for when the program fails to start after closing the door.
Reasons and solutions if the program cannot be started or selected.
Explanations and solutions for water remaining in the machine.
Troubleshooting for standby mode or water intake issues.
Solutions for issues related to the machine not draining water.
Causes and solutions for vibration and noise issues.
Troubleshooting water leaks from the machine's base.
Solutions for unexpected program stops.
Reasons and solutions for direct water discharge.
Explanation for not seeing water during washing.
Solutions for the loading door remaining locked.
Reasons and solutions for extended washing times.
Troubleshooting for countdown issues on models with displays.
Reasons and solutions for the machine not starting the spin cycle.
Causes and solutions for laundry turning gray.
Troubleshooting for stains not being removed or laundry not being whitened.
Solutions for oily stains on laundry.
Causes and solutions for unpleasant smells on clothes.
Reasons and solutions for faded clothing colors.
Solutions for poor rinsing performance.
Causes and solutions for stiff laundry after washing.
Troubleshooting for laundry not smelling like softener.
Reasons and solutions for detergent residue in the drawer.
Solutions for excessive foam formation in the machine.
Solutions for foam overflowing from the detergent drawer.
Causes and solutions for laundry remaining wet after the program.
General| Load Capacity | 6 kg |
|---|---|
| Spin Speed | 1200 RPM |
| Energy Efficiency Class | A+++ |
| Noise Level (Spin) | 76 dB |
| Noise Emission Class Spinning | B |
| Number of Programs | 15 |
| Color | White |
| Noise Level (Wash) | 58 dB |
To Next Page
