3522.5-0000010 РЭ
201
3.25 Cab
3.25.1 General information
The cab of the tractors BELARUS-3522.5 ensure comfortable working conditions, heat
and noise insulation, correspond to safety and observability requirements.
The cab has the following emergency exits:
- doors – left and right;
- rear screen;
- lateral screen – right and left.
Natural ventilation of the cab is realized through opening side and rear glasses and
through roof hatch. The cab glasses are safety and have bend form.
ATTENTION: DURING OPERATION AND REPAIR WORKS AVOID CAB
GLASSES KNOCKS!
3.25.2 Cab installation
The cab is mounted on tractor frame through vibration isolators 4 (figure 3.25.1). In
case of cab dismantling the following shall be done:
- unlock the splint pins 1;
- loosen the nuts 2;
- dismount bolts 3;
- take off the cab with a help of frame-craine with crane capacity not lower than 100
kg and using 3 eye screws M16, which are mounted on upper deck of the roof in points ¨A¨
(figure 3.25.2)
1 – splint pin ; 2 – nut; 3 – bolt, 4 – vibration isolator; 5 – bracket to fasten the cab with
coupling clutch housing; 6 – bracket to fasten the cab with the rear axle shaft.
3 – о
Figure 3.25.1 – Cab installation on vibration isolators
Figure 3.25.2 – Points of eye screws installation on the roof
https://tractormanualz.com/
To Next Page
