3522.5-0000010 OM
248
5.4 Drawbar hitch
5.4.1 General information
Tractors “BELARUS - 3522.5” are packaged with drawbar hitches, towing yoke and
draw bar ensuring coupling and transporting of trailed and semitrailed implements coupling
devices of which correspond to the following requirements:
- compatibility according to the coupling dimensions;
- implements are equipped with rigid drawbar hitch;
- draft poles are equipped with a device making the procedure of cou-
pling/uncoupling with drawbar hitch of a tractor easier;
- drawbar hitches of semitrailers have an adjustable support.
Tractor “BELARUS - 3522.5” has special-purpose rear mounting arrangement of lift
type in the form of guide plates with several borings fixed to the rear joint face of a rear
axis body. The arrangement is meant for mounting of drawbar hitches and allows height
adjustment of towing yoke.
Installation variants scheme of towing yoke is shown in Figure 5.4.1.
Installation variants scheme of towing yoke is shown in Figure 5.4.2.
Basic parameters of drawbar hitches shown in Tables 5.3, 5.4, and in Figures 5.4.1,
5.4.2, are given with rear tires 650/75R42 both single and dual mounted to the tractor and
with standard static radius, specified by the manufacturer.
Note – General information about DH is set forth in subsection 3.22 “All-purpose
drawbar hitch”.
https://tractormanualz.com/
To Next Page
