Network security support
3.10
Configure network time synchronization
52
UM Security BRS-2A
Release
8.7
05/2022
3.10 Configure network time synchronization
Hirschmann assumes that, when reading this section, you have taken the necessary steps to
securing the device itself (see on page 35 “Configure time synchronization”).
To help synchronize the time in the network, the device may act as a time server.
Configure the server function of the device. Parameters to be configured may include:
Enable the server function of the device only if necessary.
Enable only the servers for the network protocols allowed by the policy.
Tune the server functions of the chosen network time protocol on the device.
To Next Page
Loading...
