36
locally and display the icon .
Emergency Alarm Mode:
Emergency Alarm: In this mode, you can send alarm information, while receive
ACK or reach the maximum retries will exit emergency mode.
Emergency Alarm with Call: You can press programmed” Emergency On/Off” key
to send emergency information, then press PTT to transmit an emergency call.
Only Emergency Call: You can press programmed” Emergency On/Off” key to
enter emergency mode and the control center will not receive any alarm signal except
press PTT key to transmit emergency all.
1. Sending Emergency Alarm: Press the programmable button which is
programmed as [Emergency On] to send emergency information, LED indicator
glows red, the icon will show in the status bar and LCD displays: Sending
Alarm.
2. Initiate an emergency call: When the emergency mode as emergency alarm
with call, after enter emergency state, press PTT key to initiate an emergency
call, the LCD displays: Emergency Call. If the Alarm with call to follow is
enabled via the programming software, that allows user to talk without having
to press PTT key.
3. Exiting Emergency Alarm: The transmitter long press the programmable button
which is programmed as [Emergency Off] to exit emergency state or the
emergency alarm retry count is used up, the transceiver will exit alarm mode
To Next Page
Loading...
