How to fix BelFone Transceiver that cannot be powered on?
If your BelFone Transceiver won't power on, try these steps: First, remove the battery and then reattach it. If that doesn't work, recharge or replace the battery.
What to do if I cannot communicate with other members using BelFone Transceiver?
If you're unable to communicate with other members using your BelFone Transceiver, ensure your TX/RX frequency and signaling are the same as theirs. Also, move closer to the other members. If you are on a digital channel, make sure the device ID of the transmitter and receiver are the same.
Why is the voice weak or discontinuous on my BelFone Transceiver?
If the voice is weak, discontinuous, or totally inactive during receiving on your BelFone Transceiver, try the following: * Increase the volume level. * Turn off the radio and reattach the antenna. * Check the battery voltage, and if it's low, recharge or replace the battery.
How to improve unclear voice on BelFone Transceiver?
To improve unclear voice quality on your BelFone Transceiver, modify the frequency to avoid interference from other radios using the same frequency. On an analog channel, you can adjust the squelch level or set CTCSS/CDCSS.
What to do if the noise is too loud on BelFone Transceiver?
If the noise is too loud on your BelFone Transceiver, move closer to other members. Alternatively, move to an open and flat area and restart the radio. Also, stay away from equipment that may cause interference.
Why GPS cannot locate my position on BelFone Transceiver?
If the GPS on your BelFone Transceiver cannot locate your position, move to an open and flat area, and restart the GPS feature.
Guidelines and instructions for controlling RF exposure.
Safety advice to prevent radio damage and personal injury.
Lists included accessories and provides installation steps for antenna, clip, strap, and battery.
Details on battery life, charging tips, and prolonging battery life.
Overview of radio components, buttons, indicators, LCD icons, and basic operations.
Guide to selecting channels, zones, and switching between digital/analog modes.
Procedures for calls, sending messages, and reviewing call history.
Using scan lists, roam, and network features for enhanced communication.
Adjusting settings, configuring VOX, encryption, emergency modes, and priority interrupt.
TX permission, battery saver, monitor, squelch, and signaling.
Diagnosing and resolving typical radio operational problems.
Technical data for frequency, capacity, sensitivity, power, and modulation.
Information on manual accuracy, updates, and company statement.
General| Frequency Range | UHF: 400-470MHz; VHF: 136-174MHz |
|---|---|
| Channel Capacity | 1024 |
| Battery | 2000mAh Li-ion battery (Standard) |
| Digital Protocol | DMR |
| Vocoder Type | AMBE++ |
| Output Power | 5W/1W |
| Channels | 1024 |
| Operating Voltage | 7.4V DC |
| RF Power Output | 5W |
| Operating Temperature | -30℃~+60℃ |
To Next Page
