True Wireless Earbuds
Initial pairing
Step 1: Open the charging case of your earbuds, and the earbud’s
white light will begin to blink. The blue light will show once the
earbuds are ready to pair.
Step 2: On your mobile device, turn ON the Bluetooth to begin
searching for nearby devices.
NOTE: The steps in enabling your Bluetooth may vary depending
on your device’s operating system.
Step 3: When your earbuds are detected, it will show as
SOUNDFORM Freedom as a device to pair. Tap on the name
to complete the pairing.
Manual pairing
Remove the earbuds from the case. Then, press and hold the touch-
sensitive buttons on the earbuds for 3 seconds. The status light on
the earbuds will blink white and blue when they are ready to be paired.
All Day Comfort
Our True Wireless Earbuds come with
three sizes (S/M/L) of silicone ear tips,
providing all-day comfort and noise
isolation with its sealed in-ear fit.
3 sec
Audio Playback
Control Left Earbud Right Earbud
Volume up ( + ) Tap one time
Volume down ( - ) Tap one time
Pause / Resume playback Tap two times Tap two times
Next track Tap three times
Previous track Tap three times
Call Handling
Control Left Earbud Right Earbud
Accept / End call Tap two times Tap two times
Reject call Hold for 2 seconds Hold for 2 seconds
Virtual Assistants
Control Left Earbud Right Earbud
Activate virtual assistant Hold for 2 seconds Hold for 2 seconds
How to use the touch controls on the Belkin AUC002
A
B
To Next Page
Need help?
General
