PACKAGE CONTENTS
• User and Installation Guide
• Bell ExpressVu satellite antenna assembly
• Bell ExpressVu receiver
• Accessories
❒ 7.6-metre RJ11 telephone cable
❒ 2.4-metre phono (RCA) 3-connector cable
❒ 1.8-metre modulator cable
❒ 2.4-metre S-VIDEO cable (optional to install) Model 4700 only.
❒ Remote control, with four (4) AAA batteries packaged separately
In addition, we provide an optional Installation Kit, which includes the necessary
hardware and cables that you would typically use during installation. Contact the
location where your Bell ExpressVu system was purchased for more information, or call
the Bell ExpressVu Customer Service Call Centre at 1-888-SKY-DISH for the location of
a licensed dealer near you.
WHAT YOU NEED TO KNOW
Because you will make modifications to the location where you mount the satellite
antenna, we suggest that you be familiar with and be able to safely perform the following
procedures.
• You should be able to use a plumb line or level to set both horizontal and vertical
surfaces. This is especially critical for vertical surfaces.
• You should know how to drill holes in the mounting surface (whether wood, brick,
cinder block, etc.).
• You should know how to drill holes and run cabling through your building. This
includes sealing the holes once the cable has been installed.
WHAT YOU NEED TO HAVE
If you did not purchase the installation kit, you will need the following materials:
• Coaxial cables and connectors (RG6 recommended up to 100ft. For longer distances
consult an installer)
• Fastening devices to attach the mount to your dwelling
• Waterproofing for the outdoor connections
• Grounding materials
• Cable ties
Page I-6
Installation Guide
To Next Page
Loading...
Need help?
General
