SYSTEM SET-UP
COMPLETING INSTALLATION WITH MULTI-SATELLITE
‘POINT DISH’ ONSCREEN MENUS:
1. Once the satellite system installation is finished,
power on the satellite receiver and display the
‘Point Dish’ screen on the TV. Note that the
display has now changed to show satellite
reception from both satellite locations: Bell
ExpressVu 91˚ and Bell ExpressVu 82˚. (If the
‘Point Dish’ screen has not changed, power off
the satellite receiver so it can begin to download
the new Multi-Satellite software. Ensure the
receiver is set to accept upgrades via the
‘System Setup’ menu.)
2. Using the remote, confirm signal strength by
selecting one satellite and then the other.
3. Next, perform a test on the satellite system
switches by selecting ‘Check Switch’ option on
the screen. On the following display, select
‘Check’ to begin the automatic set-up for
systems installation.
4. Once the test is completed, an ‘Installation
Summary’ screen will appear and indicate the
various settings for each switch output and also
verify proper satellite reception.
Congratulations! The installation for your new
Bell ExpressVu Multi-Satellite system is now
complete! Simply call 1 888 SKY DISH (759-
3474) to activate your satellite receiver(s) and
begin enjoying Bell ExpressVu’s 100% digital quality television.
www.bell.ca/satellite
1-888-SKY-DISH
Bell is a trade-mark of Bell Canada used under license;
ExpressVu is a trade-mark of Bell ExpressVu L.P. All Rights Reserved.
Page I-26
Installation Guide
To Next Page
Loading...
Need help?
General
