Bell EXPRESSVU Installation Guide

Page I-55
Installation and Setup
Connect Receiver to Telephone Connection
You must also set up the receiver for the type of telephone system you have (touchtone or
rotary/pulse), and specify a telephone number prefix, if such a prefix is required to place
an outside call.
Note: A prefix is usually required only for business installations. For most residential
installations, the default setting of No prefix needed will enable correct operation.
In this case, all you need to do is specify the telephone type.
Do the following:
Remote
Buttons Menu Options
1 Press the remote control Menu button.
The receiver displays the Main Menu.
2. Select the System Setup option. The
receiver displays the System Setup menu.
3. Select the Installation option. The receiver
displays the Installation and Setup menu.
4. Select the Telephone System option.
The receiver displays the Telephone
System Setup menu.
5. Use the Up/Down/Left/Right arrow buttons
to move the highlight to the TouchTone
or the Rotary/Pulse option in the Phone
Type list.
Press the Select button to select the
highlighted option.
Note: A telephone number prefix is usually
required only for business installations. For
most residential installations, all you need to
do is specify the telephone system type. The
default prefix setting of No prefix needed
will enable correct operation. If this is the
case, highlight and select the Save option to
save the above setting, and stop here.
If you do need to specify a telephone
number prefix, then instead of selecting the
Save option, go on to the next step.

Bell EXPRESSVU Specifications

General

Category	Satellite TV System
Provider	Bell
Name	EXPRESSVU
Service Provider	Bell Canada
Interactive Features	Pay-Per-View
Equipment Required	Satellite dish
Service Type	Direct Broadcast Satellite (DBS)