Bell EXPRESSVU Installation Guide

18.Connect the cables labeled '82'
leading from the satellite dish
to each 'Dish 1' input on both
SW21 multi-dish switches.
Next, connect the cables
labeled '91' leading from the
satellite dish to each 'Dish 2'
input on both SW21 multi-dish
switches Finally, take cable
from the other side of the
multi-dish switch and connect
directly to each Bell Express
Vu satellite receiver. If you
possess only one satellite
receiver, use either multi-dish
switch output to connect the
cable in order to relay the satellite signal. Whichever multi-dish switch that is left un-
used will be available in case you wish to connect a second satellite receiver in future.
19.Complete installation and wiring by following the instructions in this manual.
20.After the wiring is done, complete the satellite system installation by following the
'System Set-up' instructions outlined on page I-26.
Page I-25
Installation and Setup
Multi-Satellite Antenna Installation
91
82
82
91

Bell EXPRESSVU Specifications

General

Category	Satellite TV System
Provider	Bell
Name	EXPRESSVU
Service Provider	Bell Canada
Interactive Features	Pay-Per-View
Equipment Required	Satellite dish
Service Type	Direct Broadcast Satellite (DBS)