15.Turn the dish assembly back and forth very slowly, until the signal strength bar turns
green to indicate the signal. Ensure that your body is not blocking the path between
the dish and the satellite! Note: If you cannot find the signal, turn the dish assembly
back to the original azimuth setting. Loosen the elevation bolts and increase the
elevation angle by two degrees. Tighten the elevation bolts and try turning the dish
assembly slowly back and forth. Repeat these steps, raising and lowering the
elevation, until you find the satellite signal.
16.Once you have the signal, turn the dish assembly back and forth very slightly until the
signal strength bar displays the maximum possible signal strength. Tighten the mast
clamp blots. Then, loosen the elevation bolts and adjust the elevation of the dish up
and down slightly until the signal strength bar displays a maximum signal. Do not
adjust the skew setting! Tighten all the bolts in the dish assembly so that the dish
cannot be moved.
17.Once you have the strongest possible signal, press the Cancel button on the remote
control to exit the ‘Point Dish and Signal Strength’ menu. The receiver will then
display an ‘Attention’ message on the television screen asking whether the installation
is complete. Use the remote control arrow buttons to highlight the Yes option, and
press the Select button. The receiver will automatically ‘download’ the latest operating
software. Once complete, the receiver will display a ‘Warning’ message stating that
you are tuned to a channel that has not been subscribed to.
Page I-24
Installation Guide
To Next Page
Loading...
Need help?
General
