Bell Fibe Internet - Setting an Admin Password; Changing Admin Password

15
The Connection Hub's printer USB functionality is available for use.
However, the configuration and use of this printer functionality is not
supported by Bell Internet Technical Support.
Setting an admin password
An Admin Password is used for security. If you do change your Admin
Password, be sure to write it down and keep it handy for future reference.
OnceyouhavesetanAdminPassword,youwillneedtoenteritinbefore
making any changes to the Connection Hub settings.
1. Openyourwebbrowser.
2. Type 192.168.2.1 in the address bar, then press Enter. If you are
prompted to enter in a username and password, these are set to the
following defaults:
Username: admin
Password: admin
If you have changed the default password, you must enter in that
password.
3. Click on Account Settings from the left menu.
4. Type in your current password in Current Password (“admin” is the
default password if you have not already changed it).
5. Type in a new password in both the New Password and New Password
(again) fields.
6. Click Save.
FibeInternet_ConnectionHub_ReferenceGuide_Eng_V7 15 11-06-24 4:09 PM