Bell Fibe Internet User Manual

21
Restart the Connection Hub
UnplugthepowercordfromtheConnectionHub,wait10secondsandplug
it back in. This will restart the Connection Hub without erasing your saved
settings.
Reset the Connection Hub
Reset to factory defaults
Use this option when you need to recover the factory default settings.
This might be necessary when:
 -Acustomcongurationdidnotgoasplanned.
 -Youwantanewconguration.
 -YourConnectionHubdoesnotappeartobeworkingproperly.
Important: This option resets all personalized settings on your Connection
Hub.
Press and hold the reset button on the bottom of the Connection Hub until
the power light turns off.
When the Connection Hub lights are back on, you will need to update the user
ID (b1#) and access password by following the instructions in the section titled
“Updating my Internet user ID and access password.” You will also need to
update any other settings you customized on the Connection Hub.
FibeInternet_ConnectionHub_ReferenceGuide_Eng_V7 21 11-06-24 4:09 PM

Bell Fibe Internet Specifications

General

Brand	Bell
Model	Fibe Internet
Category	Switch
Language	English