EasyManuals Logo

Bell Pickpine SPV 21 User Manual

Bell Pickpine SPV 21
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
D22001250 v.1 - UPD 191201
5.3 - How to use the movable table
The SPV 40 logsplitter is equipped with a movable table, which makes it possible to split logs up to 104 cm of lenght.
In order to split a log of 104 cm, proceed as follows:
A- : Open the movable table (2 in Fig.7), put the log (3 in Fig.8) on the fixed table (1) and then split it as pointed out in par. 5.2.
As the logsplitter is equipped with a fast-opening wedge, the log should split completely. If it doesnt, release the ZHB levers: the log
jammed in the wedge will go up together with the beam
B-: Close the movable table, BLOCK IT WITH THE LEVER (4), let down the log protection against falling (5) and split again: the wedge
will stick deeper into the log and will split it. The protection ring will prevent the log from falling down.
I WARNING
DO NOT WORK WITHOUT BLOCKING THE WORK SURFACE WITH THE PERTINENT LEVER, OTHERWISE THE USER COULD BE WOUNDED
AND THE MACHINE DAMAGED, AND DO NOT FORGET TO LET THE PROTECTION RING DOWN.
5.4 - How to adjust blade stroke
To save time, a system has been designed that makes it possible to adjust wedge travel so that this can be set for short logs. In this way, the
wedge travels for the distance required only. After checking the length of the longest logs to be split, regulate wedge travel as follows:
Start the log splitter and bring the wedge to the position required. Release one of machine control levers so that the wedge stops in the
selected position.
Back off knob 1 in fig.9a with the other hand.
Pull the rod (2 in fig.9b) up until it locks in place.
Draw up the knob (1) again making sure it is tight.
The log splitter will now reposition at the point selected.
5.5 - How to transport the log splitter
Use the carrying handle on the top part of the mast (fig. 10a) for safe, trouble-free transport of the log splitter.
Rest one foot on the base of the log splitter. Pull the handle, tilting the machine towards you to facilitate transport (fig. 10b).
To rest the machine on the ground, put one foot on the base and lower the machine carefully.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bell Pickpine SPV 21 and is the answer not in the manual?

Bell Pickpine SPV 21 Specifications

General IconGeneral
BrandBell
ModelPickpine SPV 21
CategoryLog Splitter
LanguageEnglish

Related product manuals