Bell SKIPPER Series - Assembly Instructions; Steps 1-2: Seat Support Attachment

Place the seat on its side. Insert (2) 6mm by 35mm
round head square neck bolts into the (2) holes in the
left side of the bottom of the seat.
While holding the bolts rmly in place fasten the
left seat supports to the bottom of the plastic seat
using (2) 6mm split lock washers and (2) 6mm
Nylock nuts.
Note: You cannot hand tighten Nylock nuts. An
adjustable wrench is required to complete this step.
STEP 1 STEP 2
ITEM #18
6mm x 35mm
ITEM # 19
6mm Nylock
Nut
ITEM # 20
6mm Split
Lock Washer