Bell SPV26 - Page 4

SPV26
4
English
in normal conditions of use, our machines may
expose the operator daily to noise levels lower than
or equal to 85 dB(a). it is therefore obligatory to wear
ear defenders.
Dumping of used oil in the environment is forbidden.
The oil must be disposed of according to current
legislation in the country where this operation is
carried out.
1.1 - Symbols used
Standard graphic symbols are used on all machines in order to ensure complete safety of all parts of the log splitter.
As these symbols are very important, read the information below attentively.
it is obligatory to read the machines use and
maintenance manual in full before using the machine.
it is obligatory to wear safety footwear at all times to
provide protection against the risk of logs accidentally
falling on feet.
it is obligatory at all times to wear gloves which
protect the hands against chips and splinters which
may be produced during work.
it is obligatory at all times to wear a helmet which
protects the hands against chips and splinters which
may be produced during work.
it is obligatory at all times to wear goggles or a visor
which protects the hands against chips and splinters
which may be produced during work.
it is forbidden to remove or tamper with the protection
devices and safety devices.
it is forbidden to carry out any maintenance work or to
renew parts on the machine when it is running.
it is forbidden to smoke near the machine and in the
work area.
it is forbidden to stand in the range of action of the
machine. apart from the operator, no other person or
animal may be present within a radius of 5 metres
from the machine.
Warning: direction of rotation of the
wedge.
Never touch the wedge or the
supporting arm when in movement.
Danger of cutting or crushing of the hand: never touch
hazardous areas while the wedge is moving.
Warning: never remove a log trapped in the wedge
with your hands.
Warning: voltage as indicated on the rating
plate
Danger of burns: very hot surface. Do not touch.
Direction of rotation of the
motor. If the motor runs in
the wrong direction, follow
the instructions given in
paragraph 4.1 on page 8.
make certain that the gearbox
shaft rotates in an anti-
clockwise direction and does
not exceed 540 rpm.
make certain that the gearbox
shaft rotates in a clockwise
direction and does not exceed
540 rpm.