Making coffee
ATTENTION
Risk of burns
Parts of the machine, in particular the brewing group and
portafilter as well as the steam and hot water pipes, are very
hot during operation. There is a risk of burns if touched!
► Do not touch these parts while they are hot. Only grasp
the portafilter by the insulated handle.
✓ The machine is connected to the power supply.
✓ The water tank is filled.
✓ The valves for steam and water extraction are closed.
✓ The coffee dispensing is off (lever in the down position).
1. Insert the empty portafilter:
2. To do this, insert the empty portafilter for single or double use,
rotated approx. 45 ° to the left from below into the brewing
group and turn it to the right until you feel a resistance. Screw
in tight but not too tight!
3. Switch the machine on using the on / off switch (Figure 2: 14).
↳
The machine now audibly pumps water out of the water-
tank
into the boiler. When switching on for the first time,
this can take some time as the boiler is still completely
empty. It may also be necessary to top up with water
.
↳
As soon as the boiler is filled, the pump stops and the
Water is heating up.
↳ The display (Fig. 2: 3) shows the current boiler temperature.
When the machine is switched on while it is still cold, this
corresponds approximately to room temperature.
3. Wait for the machine to reach operating temperature.
This takes about 10 minutes. The display now shows the
preset temperature of 125 ° C.
4. Loosen the portafilter by turning it approx. 45 ° to the left, fill
in the coffee powder, compress it with the tamper and reinsert
the portafilter.
5. Place one or two cups (depending on the desired cover) under
the portafilter and tilt the cover lever (Fig. 2: 11) upwards by
approx. 90 °.
↳ The coffee runs after the preset pre-brewing time
6. As soon as the required amount of coffee has been reached, stop
dispensing the coffee by tilting the dispensing lever down.
It is also possible to prepare coffee before the desired
boiler temperature has been reached. However,
because the water temperature is too low, the result
will not be satisfactory.
14 / 32
Bellezza | Espresso machines
Start up and operate the machine
To Next Page
Loading...
