12
Bellfires
English
Instructions for use and installation instructions
2.5.2 Hand-held transmitter
The remote control works by radio signal. The signal code default setting is factory set,
but may be modified if requierd.
Figure 2: Hand-held transmitter
Set the display
l Connect the batteries. By simultaneously pressing OFF and , can be
switched from °F (and 12 hour clock) to °C (and 24 hour clock), or vice versa.
l The display will automatically return to MAN mode after some time, but you
may immediately return to MAN by pressing the OFF button.
Set the current time
l By simultaneously pressing and , the display flashes. You are in SET mode.
l Press to set the hour and to set the minute.
l Wait or press OFF to return to MAN mode.
Programming the desired temperature
l Select the desired mode of operation or by pressing theSET button briefly.
l Hold the SET button until the display flashes.
l Set the temperature with or .
l Wait or press the OFF button briefly to go to MAN mode.
l If the temperature control in should be off (lower battery consumption),
decrease the night temperature until appears on the display.
To Next Page
Loading...
