46
Bellfires
English
Instructions for use and installation instructions
Connect up the convection package, if applicable.
The optional mantle iron is intended for supporting the brickwork above the hearth. The
mantle iron must rest on the brickwork on both sides so that upward building is
possible. The brickwork therefore must not rest on the fireplace; there must be approx.
2 cm clearance in connection with the weight.
If using other materials, such as stone or heat-resistant plating, you should follow the
supplier’s instructions.
Once the fireplace has been finished, you can now, for appliances with an operating
unit, fit the frame with the small door to the operating unit.
After installation in a new fireplace and/or applying new cement work, the
appliance cannot be used for at least four weeks.
3.5.4 Checking the gas connection
After connection of the gas supply, check that all connections are completely gas tight
using soapy water or a leak tester.
3.5.5 Positioning the ceramic log set, marble pebbles and ceramic stones
The appliance can be supplied with:
• Ceramic log set + embers
• Ceramic stones
• Marble pebbles
Important: • Do not place any embers, logs, marble pebbles or stones
against the pilot light burner. For that reason, the main burner
has a protective pilot-light cowl. Never remove this cowl! Make
sure that the pilot flame can burn at all times freely over the
main burner. Only in this way is proper ignition of the main
burner ensured.
Ignoring these directions could lead to a dangerous
situation.
• The burner bed (with embers) and the positioning of the logs,
marble pebbles or stones must not be changed.
• Only use those items supplied! Thesebeen rigorously
checked and the quantities adapted to the appliance.
• Replacement parts, including the ceramic mat are available
from your dealer.
• Fitting may only be carried out by a qualified person.
To Next Page
Loading...
