47
Bellfires
English
Instructions for use and installation instructions
3.5.5.1 Ceramic log set + embers
1 Place the ceramic mat on the burner in such a way that the holes in the mat are in
line with the burner openings.
2 Remove the embers (2x 100 gram) carefully from their packaging and spread them
evenly over the burner mat and the grate around the burner.
Note ! : • Small embers and their residue should not be scattered on
the burner. This can cause a blockage on the burner orifices.
• Embers must not be placed next to the pilot light burner.
• Ensure that the rear logs are approximately 3 cm from the rear
• If the burner runs on propane, make sure that all burner
openings remain free!!!
The positioning of ceramic log set varies per model.
Position the log set in one of the groupings shown below.
To Next Page
Loading...
