Belling 900Ei - Page 21

USING THE HOBUSING THE HOB
Troubleshooting with the Induction Hob
Code Problem Possible Cause Solution
Hob is not work-
ing
in display
Child lock is activated
Deactivate child
lock
Power boost not
working
The appliance is hot,
power boost is deacti-
vated when the appli-
ance is hot to protect
the electronics and
prevents the pans from
overheating
Allow the appli-
ance to cool
ER21
Control unit cuts
oafterprogram
setting
Electronics overheating
Allow the appli-
ance to cool
ER400
Check mains
cable connection
and terminals
at the terminal
block are wired
correctly
E2
Overheating of
induction coil
Pan overheating
Remove pans and
allow to cool
E8
Fan blocked or
faulty
Fan inlets are blocked
or faulty fans
Check fan inlet
at the rear of the
appliance
E6
Error on power
board
No power to power
board
Please call
Customer Care
ER03 and
continuous
tone or
Water or pans on
the glass above
the user controls
Water or cookware on
the glass over the touch
control sensors
Clean any water
on surface above
user controls/
display