Fitting the towel rail (if applicable)
• On the towel rail there are two holes, top (A) and bottom (B), these holes have corresponding holes
on the fascia at each end.
• The 2x longer screws are designed for the top hole (A) where as the remaining screw just goes
through the bottom hole (B). Both screws are M6 screws. Using the Allen key provided, tighten the
screws making sure that the towel rail is ush to the fascia, but not over tightened
A
B
Vinyl wrapped surfaces (if applicable)
Please note that heat protection kits are available online.
BEFORE INSTALLATION
If this appliance is installed near vinyl
wrappedsurfaces, we strongly recommend
using an installation kit available from the
vinyl-wrap supplier. Belling cannot accept
any responsibility for damage caused due
to installation into cabinets with low
temperature tolerances.
To Next Page
Loading...
