Glass parts
G
LASS DOOR PANELS
Do not use abrasives or polishes as
they will scratch and damage the glass.
Use a mild cream cleaner - eg; “Cif”.
Rinse away excess cleaner and dry
with a soft cloth.
Warning: Do not operate the appliance
without the glass panel correctly fitted.
Important: the inner door glass
panel can be removed for cleaning but
it must be replaced the right way up
(so the reflective side - if fitted - faces
inwards), and pushed fully in to the
stop position. To remove the glass
panel, open the door wide, hold the
top and bottom edges and slide out.
Cast iron pansupports
After cooking allow the pan-
supports to cool completely
before attempting to remove or
clean.
Before cleaning, remove any excess
fat with kitchen paper.
The pansupports can be cleaned with
hot soapy water and a nylon brush. If
any food residue is left on them leave
them to soak for a few minutes
in hot
soapy water before attempting to
clean it. Do not
use caustic pastes,
abrasive cleaning powders, coarse
wire wool or any hard implements, as
they will damage the surface.
Do not clean in a dishwasher.
30
Cleaning
To Next Page
Loading...
