Oven & Grill compartments
Remove the grill/meat pan and grid. It is best to wash these items immediately after use to
prevent stains from being burnt on when used again.
Wipe around the oven or grill compartment, removing stubborn stains with a fine soap
impregnated steel wool pad. Harsh abrasives should be avoided.
Remove the rod shelf for washing at the sink. Use a fine steel wool soap pad for removing
stubborn stains from the rod shelf and floor of the oven. Take care during cleaning not to
damage, bend or dislodge from the supporting clips the thermostat phial which is across the
back of the oven just below the roof in the oven compartment.
Oven and Grill Door and Handles
Wipe over the door outer panel with a cloth wrung out in hot soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft clean cloth.
Do not use scouring pads or abrasive powder which may scratch the surface.
Take care during cleaning not to damage or distort the Door Seal. Do not lift the Door Seal
from the Oven Front Frame, if necessary remove the seal by carefully unhooking the corner
clips.
N.B.
Care must be taken that Rating Label edges are not lifted during cleaning and
furthermore that the lettering is not blurred or removed.
Only use oven cleaners which carry the Vitreous Enamel Development Council's Approvals
symbol, and always follow the manufacturers instructions for use.
Replacement of Oven Lamps
WARNING: ISOLATE COOKER FROM SUPPLY BEFORE REPLACING
LAMP.
Open the oven door and remove the rod shelves. Use a thick cloth to grip the light glass
dome, which can be found in the upper right hand corner, unscrew anti-clockwise and lift
out. Reach into the aperture with thick cloth, and unscrew the faulty lamp anti-clockwise. Fit
replacement lamp (15W or 25W 300°C SES), refit glass lens.
The oven lamp is not covered by the guarantee.
A new lamp may be obtained from our Spares Department by calling:-
tel. 0870 458 9695 .
Models with removeable inner glass panels
When you wish to clean the interior glass of the oven door, use a screwdriver to remove the top
and bottom washers that secures the interior glass to the door, remove the glass with care.
Clean as above, but do not use house hold detergents, bleach, scouring pads or rust removers.After
drying, position the gasket back into its place. Reinstall the glass panels carefully preventing
sudden shocks.
* If
low emissive glass is
fitted, ensure the printed side is facing outwards.
28
To Next Page
Loading...
