Connect to the gas supply
Important:
• Rigid pipe work must be used for this installation.
• The 10mm bundy inlet connection is located at the base of the appliance. Other inlet sizes may be
tted at the customers request or to suit the country of destination.
This appliance must be installed into a gas supply system. This ensures that the appliance input
pressure can not fall from the nominal pressure by more than 1mbar (natural gas) or 2.5mbar (LPG).
All appliances connected to the same system are operated simultaneously.
Holes for cables and pipe work must be sized to minimize inter compartmental air leakage. The
specic ventilation requirements in this instruction book must however continue to be maintained.
BurnerVerication
Once installed all burners must be checked to ensure the appliance is operating correctly.
Grill - Following the users instructions the burner should burn with a clear blue ame without sooting
(propane), butane may have yellow tipping.
Oven - The oven should also burn without sooting, although yellow tipping is likely when using butane.
Hob - The burners should burn with a clear blue ame without sooting.
Connect to the electricity supply
1. This appliance is tted with a plug suitable for the country of destination.
2. The plug must be positioned so it is accessible to the user.
3. The mains cable should be routed so that accidental contact with the rear of the grill or the oven
cavity is impossible.
CONNECT TO THE GAS / ELECTRICITY SUPPLY
To Previous Page
Loading...
