Installing Your Cooker 45
700 & 720 installation Method 3:
Housing unit with internal height of 710mm or more.
Note:
You will not need the 4 runners and 2 trims that are packed with the oven for this
installation.
(i) When installed in a typical 600mm deep built in
housing unit, the false back should be removed
from the housing unit to provide the necessary
depth for installation.
(ii) When the false back is removed, it is normally
the case that the support shelf for the appliance
leaves a gap between the back edge and the
wall of approximately 80mm.
(iii) If no gap occurs between the back edge of the
shelf and the wall behind the unit, we recom-
mend that a gap of at least 30mm is made by
shortening the shelf.
Remove any fixings that may prevent entry of the
oven into the housing. The cabinetry should be
kept structurally sound by fixing to adjacent cabi-
nets, floor or worktop.
To Next Page
Loading...
