Belmed PC-7 - Yoke Block Stand Assembly; Flowmeter Attachment to Yoke; Rubber Goods Setup

Yoke
Yoke block stand assembly: Remove packaging from the base, column,
and yoke block. Follow the assembly instructions in the yoke block
instruction manual to complete the assembly of these parts.
Flowmeter attachment: Remove ½ in. diameter height adjustment rod
from column. (Z bracket should already be attached to the height
adjustment rod). Use the two provided screws to fasten the Z bracket to
the Flowmeter. Replace rod into column and tighten height adjustment
knob at desired height (gure 3).
Rubber goods: Connect breathing bag to bottom of bag tee. Connect
90 adapter to front of tee. Connect corrugated breathing tube to 90°
adapter. Connect nasal inhaler to other end of breathing tube (gure 6).
Connect gas supply hoses to DISS ttings located on bottom of owmeter
(gure 5).
Test machine.
Note: If optional O2 resuscitator is purchased with machine, plug hose end
into female quick connect located on bottom of machine. Depress button
to determine O2 ows through resuscitator. For demand ow test, breathe
through face mask (gure 15).
gure 3
7