To Next PageTo Next PageWhy is there no heat in my Belmont Medical Equipment?
If your Belmont Medical Equipment isn't heating, this could be due to a failure of the microprocessor or temperature sensor. If the failure happens again, get a replacement unit and contact service.
What to do if my Belmont buddy lite shows 'Over Temperature'?
If your Belmont Medical Equipment displays an over temperature warning, it may be due to repeatedly stopping and restarting the unit during high flow conditions. Try clamping the line, turning the unit off, and then powering it back on. Alternatively, the issue could stem from a failure of the microprocessor or temperature sensor. If the problem persists, obtain a replacement unit and contact service.
What to do if my Belmont Medical Equipment displays a 'Probe Fault'?
If your Belmont Medical Equipment is showing a probe fault, it indicates that the hardware temperature override circuit is not working correctly. To resolve this, turn the unit off and then power it back on. If the issue continues, it is recommended to call service.
General overview of the Belmont buddy lite in-line Blood/Fluid warmer.
Specifies the intended use and situations where the device should not be used.
Describes the complete system including battery pack, heater unit, and disposable set.
Explains how the system monitors fluid temperature and heating status.
Details alarm conditions, system responses, and LED indicators.
Explains battery capacity display, power control, and LED indicators.
Introduces the section on set up and operation of the device.
Lists critical safety warnings for device operation.
Detailed sequential instructions for setting up and operating the warmer.
Explains how fluid flow rates affect the warmer's performance.
Details alarm conditions, system responses, and troubleshooting steps.
Introduces the section on service and maintenance procedures.
Covers routine cleaning, disinfection, and visual inspection of the device.
Explains the process and materials needed for charging the device battery.
Provides steps to recalibrate the battery fuel gauge for accuracy.
Details periodic operational checks and alarm tests for system functionality.
Physical dimensions of the battery housing, battery, and heater unit.
Details battery voltage and electrical safety compliance standards.
Specifies operating and storage environmental parameters like temperature and humidity.
Covers flow rates, temperature, prime volume, and control panel elements.
Details safety features, temperature monitoring, and alarm conditions.
Describes the disposable set's characteristics, sterilization, and assurance level.
Outlines the device's electrical, medical equipment, and directive classifications.
Lists part numbers for the Blood/Fluid Warmer system and accessories.
Provides contact details for ordering parts and support.
General| Brand | Belmont |
|---|---|
| Model | buddy lite |
| Category | Medical Equipment |
| Language | English |
