Bemer Pro Ser - Display - B.BOX Classic; Classic Display Overview; Short Application Settings

33


32
Short application (intensity levels 1-10)
• Choose the desired intensity by pressing
the numbers 1-10.
• Designate the desired applicator module
[A1/A2] by repeatedly pressing [SET].
• Activate/deactivate the plus Signal
by pressing the left arrow key.
• Start the short application with
[START/STOP].
Display – B.BOX Classic Applications – B.BOX Classic
After selecting the desired ap-
plication, press the left arrow
key to switch the plus Signal
on/off.
Simultaneous operation is only
possible with 2 B.BODY applica-
tor modules connected (both
using the same duration and
intensity).
The selected applicator module
will blink both during selection
and during application use.
Memory card (if inserted)
1
Troubleshooting
(if available)
2
Volume
(in current setting)
3
Rechargeable battery
(state of charge)
4
Power supply operation
(when plugged in)
5
Menu navigation
“Settings”
6
plus Signal (if active)
7
Signal intensity (if active
HIGH/LOW, only with
B.PAD)
8
Info line
9
Applicator (lit when
connected, blinks
when selected)
10
Signal (with ongoing
application)
11
A1-A2
.
:
A1
A2
1 2 3 4 5
6
7
8
11
10
9
Example – Short application at intensity 6 (2 B.BODY applicator modules connected, port A1 selected)