16 17
HOW TO USE (CONT.)
11. Night Light
• Hold the “+” button for 3 seconds while the seat is not
occupied to turn on/off.
12. Automatic Tank Draining
• The tank will automatically drain and refill if the seat is not used
for 48 hours. Hold the Stop and Water Temp buttons for
3 seconds to turn on/off.
13. Sitz Bath
• Press the nozzle cleaning button after selecting a cleansing
function to activate a 5 minute low pressure wash.
14. Seat Sensor Bypass
• Hold the massage button for 3 seconds to activate or deactivate the
seat sensor. This will allow the seat to be used without being occupied.
15. Reset
• Hold the stop button on the side control panel for 5 seconds.
The seat will turn of after 3 seconds. Keep holding for another
2 seconds to complete the factory reset.
16. User Preset
• Nozzle position, water pressure, and temperature settings
can be preset and stored for 2 users.
How To Set Up User Presets
• Activate a cleansing function and adjust the settings to your preference.
• Preset 1: Press and hold the stop and buttons together for 3 seconds.
• Preset 2: Press and hold the stop and buttons together for 3 seconds.
• Press the stop button or simply wait to complete setup.
How To Activate User Presets
• Activate a wash cycle.
• Press the selected user preset button to automatically apply settings.
17. Deodorizer
• The deodorizer is turned on by default. To turn it off, press and hold the
STOP and ENERGY SAVING buttons for 3 seconds
To Next Page