What to do if water pressure is too low on BEMIS Toilets?
If the water pressure is too low in your BEMIS Toilets, try increasing the water pressure settings. Also, check the inlet filter; if it's blocked, clean the filter mesh or replace the water filter.
Why is there no water in the nozzle of my BEMIS Toilets?
If there's no water flowing from the nozzle of your BEMIS Toilets, first, ensure that the water supply hasn't been cut off and restore it if needed. Next, check the angle valve to make sure it's open. Also, inspect the water inlet filter for blockages and clean or replace it as necessary. Finally, ensure the inlet pipe is straight and not flexed.
How to fix BEMIS Toilets product not flushing clean when water pressure is low?
If the product is not flushing clean when water pressure is low for BEMIS Toilets, clean the filter according to the instructions manual. Check whether the water amount is below 3L every 10 seconds or not. If it is, we suggest you buy a pressure increasing valve. Also, reconfigure the hose to a more smooth connection.
To Next Page
General