15
TESTING
Testing the Water Flow
1. Open the water supply valve.
2. Check each connection for leaks
3. If leaks occur, turn off the water supply valve and
re-connect the leaking components.
Connecting Power
1. Plug in the power cord.
2. Check to see if the power light is on.
If not, push the reset button.
3. Once the power light is on, the toilet will run its
initial diagnostics: lights will turn on, cleaning
nozzle will extend, the motor will begin to run and
water will run through the system. Once the light is
off, the self-diagnostic is complete.
Testing the Product
1. Are all the functions working properly? Please
test all of the following functions: Posterior Wash,
Front Wash (including water pressure and nozzle
position adjustment), Heated Dryer, Water and
Seat Temperature Adjustment, Nozzle Cleaning,
Deodorization, and Remote Control.
2. To check the posterior wash, place a hand on
the sensor point (shown in the illustration), press
Posterior on the Side Control Panel or the wireless
remote. Use your hand to block the nozzle spray.
seat sensor
To Next Page
Loading...
