200663_03 Page 4
Operation manual control
M
ANUAL ON/OFF SWITCH
This switch turns heater on / off and permit / prohibits use of remote and panel
push buttons.
FLAME BUTTON
By pressing the flame effect button the unit will cycle through three flames.
HEATER BUTTON
Press once turns 1000W power on.
Press again turns 2000W power on
THERMOSTAT SETTING
The knob is marked with numbers to indicate the maximum and minimum
temperature positions. Start with setting 9 and to decrease the temperature
turn knob to left to a lower setting. To increase the temperature, turn knob to
right to a higher setting.
Operation by Remote Handset
Make sure the batteries are installed properly in the remote control.
The effective range of the remote control is up to 4 meters or 13 feet.
Ensure that the master on switch (Left hand side) is set to the on (I) position.
• Press the “POWER” Button, this turns the flame effect settings to the last used
setting.
• Pressing the “FLAME” button changes the intensity of the flame illumination,
this button can be pressed repeatedly to cycle between the HIGH, MEDIUM
and LOW settings for the Flame illumination.
• Pressing the “BACKLIGHT” button cycles through the four settings of OFF,
YELLOW, BLUE and MIX.
• Pressing the “LOW” button activates the 1KW heat setting, pressing the “LOW”
button again turns off the heating*. To increase the heat output the “HIGH”
button can be pressed to activate the 2Kw output setting.
• Pressing the “HIGH” button activates the 2KW Heat setting, repressing the
“HIGH” button turns off the heating*. To decrease the heat output the “LOW”
button can be pressed to activate the 1Kw output setting.
• When the heater is turned on there will be a brief period (aprox 6 secs) where
the heater will blow cold air. This is to clear the elements of any debris (Dust,
Hair etc) that may have collected on the element. Similarly once the heater is
switched off the fan will blow cold air through the elements ensuring that the
elements are re cooled before turning off the fan
To set the temperature:
The knob is marked with numbers to indicate the maximum and minimum temperature positions. Start with setting 9 and when the room has
reached a desired level turn the knob slowly to left until the thermostat ‘clicks off’. The thermostat will then maintain the room at the selected
level. To increase the temperature, turn knob back to right to a higher setting.
Safety thermal cut-out
This appliance is fitted with an Electric Safety Control (E.S.). This is a safety device, which switches off the fire if, for any reason, the
appliance overheats. The E.S. Control can only be re-set after the appliance has cooled down, in Order to re-set the E.S. Control, proceed as
follows:
Switch off the appliance. Unplug at wall socket and leave for approximately 5-10 minutes.
Plug in switch on appliance and the E.S. Control will re-set.
Ensure that the appliance is functioning correctly. If the E.S. Control switches off again it is advisable to have the appliance checked by a
competent electrician.
To Next Page
Loading...