EasyManua.ls Logo

bemodern 1198 - Maintenance; Replacing the LED Flame Effect; Environment

bemodern 1198
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
200663_03 Page 5
Note: -This appliance also has a secondary thermal fuse link incorporated into the heating element that will break the electrical circuit in the
event that the heater fan fails to operate. Unlike the E.S. if this link breaks the fire will not be allowed to re set and the appliance should be
checked by a competent electrician and the fan/element replaced.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Maintenance
Warning: Before undertaking any maintenance or cleaning disconnect appliance from main supply. Only competent persons should service /
repair appliances.
Remote Handset Battery Replacement
Replace with two AAA batteries. Make sure the batteries are installed correctly in the remote control.
Maintenance of Motors
The motors used on the fan and flame effect are pre-lubricated for extended bearing life and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is recommended.
Warning: An authorized service representative should perform any other servicing.
Cleaning the appliance
You can clean the exterior of the fireplace with a soft, damp, lint-free cloth. Do not use cleaning or polishing products. To remove fingerprints
or other marks on the front glass panel, use a soft, damp, lint-free cloth with a good quality household glass cleaner. The front glass panel
should always be completely dried with a clean, lint-free cloth or paper towel.
Caution: Do not use abrasive cleaners on the glass panel. Do not spray liquids directly onto any surface of the unit.
Please note if the supply cord on this appliance is damaged it must be replaced by the manufacturers Authorised Service Agent, or a qualified
person to avoid hazard.
Replacing the LED Flame effect:
The LED lighting used in this fire should last for the lifetime of the unit, however if required this component should only be replaced by a
qualified electrician.
Environment
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact you
local authority for information regarding the collection systems available. If electrical appliances are disposed of in
landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your
health and well-being. When replacing old appliances with new ones, the retailer is legally obligated to take back your
old appliance for disposals at least free of charge.