S.p.A. BT 2001 R
21
Fig.18
Fig.19
Ref. 1 Fig. 19 refers to the electrodes of the battery.
28) ELECTRICAL SYSTEM
NOTE
For information on the wiring diagram, contact the Technical Assistance Service.
Battery:
Read carefully the instructions supplied by the manufacturer.
Check the fluid level in the battery and top up with distilled water necessary. Do not over fill, above the top line.
Check the Battery terminals are tight, and protect them with Vaseline.
If it is necessary to change the battery, disconnect the terminals (see figure 19 particular 1), by removing the two
screws. Remove the locking plate by unscrewing the screw Ref.2 Fig.19.
Battery voltage: 12 V.
ADVICE
When welding the chassis of the tractor, disconnect the alternator Ref.3 Fig.19. The tractor is equipped with a
protective fuse wire of 40 A, blade typed, placed in the position indicated in Fig.19 Ref.4.
To Next Page
Loading...