Benassi BT 2001 R - Periodical Maintenance

S.p.A. BT 2001 R
18
FRONT AXLE ADJUSTMENT
Track adjustment on the front axle allows 4 different widths, as shown in the preceding tables. To adjust the track,
loosen and remove the nuts and bolts (2 on the left, Ref.1 fig.14 and 2 on the right, Ref.1 fig.15) adjust the axle. Replace
the bolts in the appropriate position. Refit the nuts. Finally, adjust the steering connecting-rod ref.2 fig.14.
Fig.14 Fig.15
ADJUSTING RIMS OF REAR-WHEELS
Ref.1 Fig.16 and Ref.2 Fig.16, show the adjustment points for the rear
axle. Three widths are available; the measurements are indicated in
the table above.
Fig.16
25) MAINTENANCE
PERIODICAL MAINTENANCE
Use only original spare parts, to ensure maximum
efficiency of the machine.
ATTENTION
Before starting maintenance operations, read the
instructions in the paragraph "SAFETY NOTES".
ADIVICE
Ø Oil level checks are to be made with the machine in a
level position and with the engine stopped for at least
10 minutes.
Ø Change the oil while still warm; in order to facilitate
emptying.
ATTENTION
Oil change operations must be done in conformity with
pollution regulations.
The table below shows the maintenance and lubricating
operations that are to be done periodically.
NOTE
The working hours of the machine are measured by the meter fitted to the dashboard of the tractor (ref.10 fig.3). The
following paragraphs describe maintenance operations in detail.