S.p.A. BT 2001 R
20
Ø Drain plug is found underneath the gear box Oil
filler cap Ref.4 Fig.6
Greasing
Every 50 hours grease the steering-gear box, by means
of the grease nipple on the steering box. If you have
used the PTO shaft, grease the relative joints, following
the instructions contained in the paper attached to this
accessory.
Use AGIP GREASE LP2 grease.
26) WATER BALLASTING
Raise the rear wheels, rotate till the valve is
uppermost. Remove the valve cap and remove the valve,
to deflate the tyre.
Connect the valve to a water supply and fill.
Interrupt the operation now and again; in order to let
the air out.
Stop the operation when water comes out of
the valve: the tyre contains almost 40 litres of water.
Refit the valve, inflate and replace cap,
To empty the water, raise and rotate the
wheel until the valve is at its lowest position, then
remove the valve.
Advice: Ballast the tractor only when it is
necessary and follow the instructions. In freezing
conditions, use antifreeze.
ATTENTION: This kind of ballast is to be used on the
rear-wheels only and in particular work conditions, i.e.
when the tractor slips.
27) ADJUSTMENTS
The following important adjustments must be carried
out. These adjustments are particularly simple; in case
of problems, call our Assistance Service.
Adjusting the clutch connecting rod.
If the free play of the pedal is less than 10 mm,
readjust using the adjuster (Ref.1 - Fig.17), found under
the left footboard.
Adjusting the service brake
If the wheels brake differently, or if the pedals arrive
at end stroke when they are pressed, apply on the
adjustment devices (Ref.2-Fig.17), for the left pedal
brake, or apply on the device Ref.1 Fig.18 for the right
pedal brake. Make adjustments on both wheels
separately.
It is possible to adjust the stroke of the manual brake
lever, by applying on the devices Ref.3 Fig.17 (which are
connected with the left brake) or on the devices Ref.2
Fig.18 (which are connected with the right brake).
Adjustment of the accelerator cable
To adjust the stroke of the throttle lever, apply on the
adjustment screw placed under the throttle lever.
Front Wheels Convergence
The convergence of the front wheels can be adjusted
according to measures reported in the chapter “TRACK
ADJUSTMENT”, at the point “FRONT AXLE
ADJUSTMENT”
Fig.17
To Next Page
Loading...