OPERATION AND MAINTENANCE MANUAL
Page 14 of 22
Starting the machine
To start the machine, follow these instructions:
BEFORE STARTING THE MACHINE, MAKE SURE THAT:
- VENTILATION IS ENOUGH (YOU SHOULD GO OUTSIDE);
- ALL THE CONTROL LEVERS ARE DISENGAGED; THE SPEED LEVER MUST
BE SET ON NEUTRAL POSITION (0);
- THE FUEL TANK IS FULL ENOUGH.
FINALLY, OPEN THE FUEL TAP
1 – With your left hand, press
the red lever (motor-stop)
2 – With you left hand, while
keeping on pressing the red lever,
grip the clutch lever
3 – While keeping the two
levers, with your right hand
press the button on the side
4 – Now, loose the levers while
keeping on pressing the button
5 – Open the throttle fully
6 – Standing in front of the
machine, grip the self-winding
rope
7 – Pull the rope strongly: the
engine will start
In this way the gear is
disengaged from the engine
and the machine can be
started
6’ – Turn the key: a warning light will light up.
Then turn the key again and loose it when
the engine is running.
If the machine has manual starting,
with self-winding rope (see the
engine operating and maintenance
manual):
If the machine has ignition (see the
engine operating and maintenance
manual):
You can unlock by gripping the
clutch lever completely.
To Next Page
Loading...
