OPERATION AND MAINTENANCE MANUAL
Page 19 of 22
Gear: changing the oil
The machine must be switched off and placed on a flat surface.
After the first 50 working hours, change the gear oil. Then change it every 300 working hours.
Empty the gear by taking off the plug shown in the picture. Collect the oil in a proper container. To fill up, put
the plug in its place and tighten. Then, pour oil through the hole with proper tools and methods.
Picture 15 – Changing gear oil
Waste oil should be disposed of according to law.
TO FILL UP, USE 90 W OIL
Greasing power takeoff
The machine must be switched off and placed on a flat surface.
Grease the power takeoff every 8 working hours and whenever attaching a new implement.
Picture 16 - Greasing takeoff
Periodical operations
The machine must be switched off and placed on a flat surface.
Periodically, check if screws, nuts, bolts, split pins etc. are well tightened.
To Next Page
Loading...
