5 GAL(19L) AIR COMPRESSOR
1635-709
High pressure air could result in death or serious injury. Never operate above maximum
operating pressure of the spray gun or tool.
Hot compressor surfaces could result in serious injury. Allow compressor to cool before
touching.
NOTICE
If the pump has been transported or turned upside down (even partially),
allow the pump to sit in a normal, upright position (FIG. A) for approximately
10 minutes before starting.
4. Close the tank ball valve(1) . Plug-in the power cord(2) (FIG. G).
5. Set the power switch to the ON position and allow the tank pressure to build. Motor will stop when
tank pressure reaches cut-out pressure(Fig H).
1. Set the power switch (1) to the OFF position.
2. Unplug the power cord (2).
3. Reduce the pressure in the tank through the outlet hose. Pulling the safety valve ring (3) and
keeping it open will also reduce the pressure in the tank(fig. I).
4.Set tank ball valve(4) (fig. I) to OFF to ensure tank is drained.
Shut down
2
FIG. G FIG. H
OFF
ON
1
To Next Page
Loading...