Risk of serious eye injury from moisture and debris. Always wear ANSI Z87.1 safety goggles
when opening ball valve.
High pressure air could result in death or serious injury. Shut off unit, unplug and release air
pressure prior to servicing.
High pressure air containning water condensation could result in minor or moderate injury. Do
not spray at any person.
1. Set the power switch to the O (OFF) position.
2. Turn air pressure regulator knob counter-clockwise to set the outlet pressure to zero.
3. Pull and hold ring on safety valve, allowing air to bleed from the tank until air pressure is
minimized.
4. Place a suitable container under the unit to catch any water.
5. Slightly tilt unit and turn ball valve counter-clockwise to open.
6. After the water has been drained,close the ball valve(clockwise). The air compressor can now be
stored.
Drain the tank
FIG. I
1
2
3
4
CAUTION
To Next Page
Loading...