Benchmark 5125-016 - Battery Charge Status and Charging; Checking Battery Charge Level; Charging the Battery Pack

5125-016
40V MAX BRUSHLESS LAWN MOWER
14
UPPER HANDLE BAR
1. Align the upper handle bar to the lower handle bar and ensure the foam handle
is pointed up when viewed from behind.
2. Pass the bolts through the mounting holes of handles (Fig. 2).
3. Attach the washer to the bolt and secure the upper handle bar by turning the
lever up for tightening (Fig. 2).
4. Secure the control cord with two wire clips (Fig. 3).
GRASS CATCHER/MULCHING OPTION/SIDE CHUTE
1. Align and insert the carry handle into the slots of top frame of grass catcher
until both ends "click" into place (Fig. 4).
2. The grass catcher is ready for use.
3. If you choose the mulcher function, then ensure the plate is inserted over
the grass chute, do not install the grass catcher. Remove plate to use
the grass catcher.
WARNING: Do not attempt to use the product without the grass catcher
catcher or the mulching plate installed. The grass catcher must be fully assembled
4.
5. Align and hook the grass catcher into the attachment slots of rear discharge chute.
FIG. 2
FIG. 4
FIG. 3
5125-016k EnProdManual P.indd 14 2020-12-17 2:09 PM
FIG. 5