21
MAINTENANCE
WARNING:
the safety key and let the mower cool down before performing inspection,
maintenance and cleaning work!
1. Remove debris after each use and before storage.
2. Regular and proper cleaning will help ensure safe use and prolong
the life of the mower.
3. Inspect the mower before each use for worn and damaged parts.
WARNING: Only perform repairs and maintenance work according to these
GENERAL CLEANING
1. Clean the mower with a dry cloth. Use a brush for areas that are hard to reach.
2. Remove stubborn dust with compressed air (43 PSI).
NOTE: Only perform repairs and maintenance work according to these
3. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using
the product again.
WARNING: Wear safety gloves when working on the blade and close to it!
Use proper tools to remove debris, e.g. a wooden stick! Never use your bare hands!
Always use original spare parts for replacement. Do not attach any other type of
1. Keep the underbody and blade clean and free of debris. Remove clippings
from the rear discharge chute.
2. Check all fasteners, such as nuts and bolts, periodically for tightness before
operation. After prolonged use, especially in sandy soil conditions, the blade
will be reduced and the blade should be replaced.
3. Keep the blade sharp to ensure a good cutting performance. Replace a worn
or damaged blade with a new one of the same type or have it sharpened by a
4. Loosen the hex bolt anticlockwise using the supplied hex wrench and remove
it together with the washer and the blade (Fig. 13).
5. Replace the blade with a new one of the same type. Check the status of the
the washer and the hex bolt. Tighten the hex bolt clockwise to 33-44 ft/lbs to
ensure safe operation of your product.
5125-016k EnProdManual P.indd 21 2020-12-17 2:09 PM
To Next Page
Loading...
