17
OPERATION
INSTALLING THE BATTERY PACKS
1. Open the battery compartment cover.
2. Unplug the safety key (1) (Fig. 8).
3. Remove the discharged battery packs by pressing downward on the battery
release button and sliding the battery pack backward until it is removed from
the battery compartment (Fig. 8).
4. Slide the fully charged battery packs onto the matching taps in the battery
compartment where the discharged battery packs have been removed.
5. Reinstall the safety key.
6. Close the battery compartment cover.
CUTTING HEIGHT ADJUSTMENT
WARNING:
to a complete stop before adjusting the cutting height!
Remove the safety key before adjusting the cutting height!
Adjust the cutting height according to the needs of your lawn. The cutting height
depends on the kind of lawn and its actual height. When mowing high grass,
start with the maximum cutting height and make a second cut with a lower
cutting height.
1. Press the lever towards the rear wheel (Fig. 9).
2. Move forward or backward to adjust the cutting height.
3. Release the lever and ensure it is engaged in the slot properly.
WARNING: Ensure that the lever engages in the slot after each adjustment.
NOTE: There are 6 cutting height levels available. The adjustable heights are 1"
(25 mm) to 3" (75 mm).
WARNING: Make sure the grooves in the sides of
the battery slide over the matching tabs of the battery
compartment. The battery release button will “click”
into place when the battery is fully installed.
WARNING: Do not immerse the battery pack
in water. Sudden cooling could cause a hot battery
to explode or leak.
NOTE: Mower will only operate when both batteries
are charged and installed.
FIG. 8
5125-016k EnProdManual P.indd 17 2020-12-17 2:09 PM
1
To Next Page
Loading...
